TM 9-4120-378-14
4.29 CAPACITORS. - Continued
Remarks
Action
Location/Item
c. If the capacitor has a metal case, check for short
Test
circuits to case by placing the positive (+) lead of
Continued
the ohmmeter on the positive terminals of the
capacitor and the negative (-) lead on the case.
There will be no deflection of the ohmmeter
needle if the capacitor is good. If the needle
does deflect, replace the capacitor.
Compressor
Run Capacitor
(10)
See Wiring Diagram (Appen-
a. Install good compressor run capacitor (10) into
Installation
strap (9).
b. (Model A9KH-115P) Tighten screws (8) using
offset screwdriver.
(Model F9000H-1S) Install screws (8) and nuts
(11 ) using screwdriver and wrench.
c. Connect the leads and remove tags.
d. Slide rubber boot (7) over leads.
e. Install the top rear cover.
Fan Motor
Capacitors (6)
and
Compressor
Start Capacitor
3)
a. Solder resistor (6) to compressor start capacitor
Installation
(4) terminals.
Perform Steps b. and c. only if
b. Install capacitors (4 and 5) in securing straps (2
capacitors were replaced.
and 3).
c. Tighten eight screws (1) attaching capacitors (4
and 5) and securing straps (2 and 3) to underside
of rear top cover.
d. Reconnect wiring.
See paragraph 4.17.
e. Install rear top cover.
