TM 9-4120-378-14
4.36 CONDENSER FAN. HOUSING AND MOTOR-INSPECT/TES T/REPLACE. This task covers removal,
disassembly, inspection, test assembly and installation.
INITIAL SETUP
Equipment Conditions:
Rear and center top covers removed (paragraph 4.17)
Condenser louver removed (paragraph 4.21)
Compressor start relay removed (paragraph 4.27)
Remarks
Action
Location/Item
Disconnect air conditioner power supply
before doing maintenance work on the
electrical system.
Top of Housing
a. Disconnect electrical connector (1) for solenoid
Removal
coil L2 from bulkhead.
b. Remove plunger nut (2) and nameplate (3), and
remove solenoid coil (4) from plunger (5).
Tag and disconnect the motor connectors.
c.
Remove four screws (6) and four flat washers (7)
d.
securing motor mounting plate (8) to housing.
Remove wire ties as required.
e.
4-96
