TM 9-4120-378-14
4.41 MAIN POWER INPUT CONNECTOR (J1) AND AUXILIARY POWER INPUT CONNECTOR (J11)-
INSPECT/RE PLACE. This task covers inspection, removal, test, repair and installation.
INITIAL SETUP
Test Equipment:
Materials/Parts:
Solder (Item 2, Appendix E)
Continuity tester
Flux (Item 15, Appendix E)
Equipment Conditions:
Top covers removed (paragraph 4.17)
Evaporator inlet louver removed (paragraph 4.18)
Action
Remarks
Location/Item
Disconnect air conditioner power supply
before doing maintenance work on the
electrical system.
Inspect all installed wiring for cracked or frayed
Inspection
insulation.
Repair or replace bad wiring.
Inspect electrical connectors for damage.
Replace damaged connectors.
Use Wiring Diagram (Appen-
Tag all wire leads prior to removal.
Removal
dix F).
