TM9-4120-398-14
4-17. CONTROL BOARD PANEL (cent)
WARNING
Dry cleaning solvent (Federal Specification P-D-680) used to clean parts is potentially dangerous to
personnel and property. Do not use near open flame or excessive heat. Flash point of solvent is 100 F
to 138 F (38C to 59 C).
(b) Using solvent (item 15 Appendix E) and a cleaning cloth (item 12 Appendix E), clean off remaining
adhesive.
(c) Coat the mating surfaces of the metal and gasket with adhesive (item 1 Appendix E). Let both surfaces
air dry until the adhesive is tacky but will not stick to fingers.
(d) Starting with an end, carefully attach the gasketto the metal. Press into firm contact all over.
c. Installation.
(1)
Place the control board panel (3) back into position.
(2)
Secure panel to frarne with eight screws (2).
Tighten two fasteners (1).
(3)
(4)
Install new instruction plates on panel as required. (See paragraph 4-10.)
