TM 9-4120-408-14
6-5. EVAPORATOR HOUSING MAINTENANCE. (Continued)
(b) Position handle (3) on evaporator housing (1) and secure with five new rivets (4).
(5) Replace damaged or missing identification plate (6) as follows:
(a) Remove and discard four rivets (5) and remove identification plate (6).
(b) Position identification plate (6) on evaporator housing (1) and secure with four new rivets (5).
(6) Replace or repair evaporator housing (1) if it is unable to protect components from environmental damage
or provide EMI shielding.
(7) Refer to TM 5-625 and TM 5-745 for sheet metal repair procedures.
(8) Inspect all rubber sheets on interior of evaporator housing (1). Refer to Appendix F, Figure F-12 to repair
damaged rubber sheets.
NOTE
Add 2 oz (57 g) of oil if the evaporator is removed from the system.
c. Install . Follow on maintenance:
(4) Refer to paragraph 5-24 and install evaporator single row terminal board.
(6) Refer to paragraph 5-22 and install evaporator wiring harness, A106J1.
(11) Refer to paragraph 5-17 and install evaporator side panel assembly.
(12) Refer to paragraph 4-29 and install front (air inlet) evaporator EMI/RFI ventilation panel.
Change 1 6-7/(6-8 Blank)