TM 9-4120-411-14
Figure 4-50. Outside Coil Temperature Sensor (RT3).
b. Installation. See figure 4-50.
(1) Secure outside coil temperature sensor (5) to coil using small tiedown strap (4). Cut to remove excess tiedown
strap material.
(2) Connect outside coil temperature sensor leads (2) with two splices (3) per paragraph 4.16 using tags and wiring
diagram figure 4-14. Remove tags. Secure leads with two large tiedown straps (1). Cut to remove excess
tiedown strap material.
(3) Lower and secure cover per paragraph 4.2.
(4) Connect FDECU to power source and operate per paragraph 2.4.
4.52 COVER RETAINING ROD REPLACEMENT.
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Materials/Parts
General Mechanics Tool Kit
Lock Washers (qty 2)
Item 1, Section III, Appendix B
Item 13, Appendix G
a. Removal. See figure 4-51.
WARNING
Rotating parts and lethal voltage levels are used in operating the FDECU. Be sure
power source is disconnected. Injury or death can occur if connected to power
source.
(1) Shutdown the FDECU per paragraph 2.4 and disconnect it from power source.
4-121
