C-2
TM 9-4935-481-14-2
Table 5-1. General Purpose Maintenance Materials-Continued
Table 5-1. General Purpose Maintenance Materials-Continued
NOMENCLATURE
PART NO. or NSN
APPLICATION
NOMENCLATURE
PART NO. or NSN
APPLICATION
Insulation
MIL-I-23053/2
As required.
Gasket, Shielding
MIS-11284-11
For fabrication of gasket around DMM on
Sleeving
DMS-D.
Insulation
MIL-I-23053/6
Tracker header connections.
Silicone Rubber
11207544
For fabrication of padding in DMS-D lid.
Sleeving
125 Red
Sheet
Insulation
MIL-I-23053/5
As required.
MILC46842
For fabrication of DMS protective padding.
Sleeving
125
Humidity
MS20003-2
For installation in DMS during operation
Indicator
in high humidity environment.
Insulation
MIL-I-23053/5
As required.
Sleeving
187
Section II.
CORRECTIVE MAINTENANCE
Insulation
MIL-I-23053/5
As required.
5-3.
General.
Sleeving
.250
5970-00-815-1295
a.
This section contains data necessary for performing corrective maintenance on the DMS test units and organic
Insulation
MIL-I-23053/5
As required.
contains data pertaining to the DMS-G and accessories.
Sleeving
.375
b.
In most cases, removal and replacement is obvious by illustration (refer to appropriate supply publications).
Therefore, these procedures will cover only those areas that require special instructions.
Insulation
MIL-I-23053/5
As required.
Sleeving
093
c.
Paragraph 5-4 contains general maintenance instructions which apply to
all items of
DMS equipment.
d.
Following repair or replacement of any items which affect operation, the appropriate maintenance
Sandpaper, #120
For sanding metal parts prior to applying
calibration/performance test as outlined in paragraph 5-1 will be performed.
(50 sheet package)
adhesives.
e.
Table 5-1 contains a
list of
general purpose materials used in
performing maintenance on
DMS equipment and
Desiccant,
For installation in DMS-D and DMS-G during
Dragon system hardware. A thorough knowledge of the application column of table 5-1 will ensure the proper materials are
8-unit bag
operation in high humidity environments.
used and prevent damage to vulnerable items.
Coating, Epoxy
MILC22750
External green paint.
f.
Table 5-2 contains a
list of
cable assemblies and the special tools required to
repair them. See paragraph 5-7 for
C1. 1 TY 2-24052
repair procedures.
Coating, Epoxy
MILC22750
External gray paint.
g.
able 5-3 contains a list of special tools which are called out in preventive or corrective maintenance procedures for
C1. 1 TY 2-26492
one or more items of DMS or Dragon hardware. This list does not include those cable connector tools listed in table 5-2.
Grommet, Plastic
MS21266-IN
Used to protect wires from edges of thin
metal panels.
Grommet, Plastic
MS21266-3N
Used to protect wires from edges of thick
metal panels.
Gasket, Conductive
MIS-11284-1
For fabrication of conductive gaskets on
DMS panels.
5-4