TM 9-2330-213-14&P
This Task Covers:
Removal
Installation
a.
b.
Initial Setup:
Equipment Conditions:
Materials/Parts:
InterVehicular cable disconnected from towing
vehicle (para 2-12).
Tools/Test Equipment:
General mechanic's tool kit
NOTE
Chassis wiring harness (2) removal is the same for all models except Ml 05A1 and
M107A1 which have five plug connectors (8) at front of trailer. All other models have
six plug connectors.
1.
Tag wires for installation if identification bands are missing or not legible (para 4-20).
2.
Remove six plug connectors (7 and 8) from clips (6) and disconnect.
3.
Remove screws (9) and clamps (1 O) from drawbar (11).
4.
Remove three plug connectors (12 and 13) from clips (14) and disconnect. Repeat on opposite side of
trailer.
Remove eight screws (1), clamps (3), and chassis wiring harness (2) from framerail (5) and
5.
crossmember (4).
INSTALLATION
b.
NOTE
Chassis wiring harness (2) installation is the same for all models except Ml 05A1 and
Ml 07A1 which have five plug connectors (8) at front of trailer. All other models have
six plug connectors.
Position chassis wiring harness (2) and clamps (3) on framerail (5) and crossmember (4) and install eight
1.
screws (1).
Connect three plug connectors (12 and 13) and install in clips (14). Repeat on opposite side of trailer.
2.
3.
Connect six plug connectors (7 and 8) and install in clips (6).
4.
Secure chassis wiring harness (2) to drawbar (11) with clamps (10) and screws (9).
