DOOR SWITCHES, 110-VOLT - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
WARNING
Contact with live 110-volt electrical wires could result in serious injury or death. Make
sure power source is disconnected before performing maintenance on the electrical
system.
NOTE
Tag wires to aid in installation (page 4-4). Both door switches are removed and
installed the same way. This task is for one; repeat for the other.
REMOVAL
Four captive
Using 3/16-inch flat-tip screwdriver,
1.
Cover (1) and
screws (3)
unscrew.
switch body (2)
Take off.
Cover (1) and four
2.
Switch body (2)
Screws will stay with cover.
captive screws (3)
NOTE
Tag wires to aid in installation (page 4-4). If circuit marker bands are missing or not
Three contact
a. Move insulator flap (7) aside.
Three
3.
b. Using 3/16-inch flat-tip screwdriver,
screws (5) and
contacts (4)
washers (6)
unscrew and take off.
Pull off.
Three wires (8)
4.
Three screws (10)
Using number two cross-tip screwdriver,
5.
Switch body (2)
unscrew and take off.
and van body (9)
Take off, and separate.
Switch body (2)
Van body (9)
6.
and plate (11)
Two screws (13)
a. Mark actuator (12) location for
7.
Actuator
and Iockwashers (14)
installation.
and van body (9)
b. Using number two cross-tip screw-
driver, unscrew and take off.
Actuator (12)
Take off.
8.
Van body (9)
INSTALLATION
Actuator (12)
Put in place.
9.
4-38