TM 9-2330-227-14&P
CIRCUIT BREAKER, 110-VOLT - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
INSTALLATION
b. Pull circuit breaker (11) away from
6. Continued
plate (10) and take out.
Circuit
a. Lineup prongs on circuit breaker (11)
7.
breaker (11)
with slots in plate (10).
b. Put circuit breaker prongs in slots on
plate (10).
c. Push in until seated.
Screw (9)
Screw in, and tighten using 3/16-inch
8. Ground tab (7) and
flat-tip screwdriver.
ground plate (8)
Wire (5)
Put in place.
9. Contact (4)
Screw (6)
Screw in, and tighten using 3/16-inch
10. Contact (4)
flat-tip screwdriver.
and wire (5)
Cover (1)
Put in place.
11. Box (2)
Four screws (3)
Screw in, and tighten using 3/16-inch
12. Cover (1) and
flat-tip screwdriver.
box (2)
NOTE
FOLLOW-ON MAINTENANCE: Check operation of circuit breaker (page 2-8).
TA231239
TASK ENDS HERE
4-41