TM 9-2330-227-14&P
DOOR SWITCHES, 110-VOLT - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
INSTALLATION - CONTINUED
Screw in, and tighten using number two
Two Iockwashers (14)
10. Actuator (12)
cross-tip screwdriver.
and screws (13)
and van body (9)
Put in place.
Plate (11) and
11. Van body (9)
switch body (2)
Three screws (10)
Screw in, and tighten using number two
12. Switch body (2)
cross-tip screwdriver.
and van body (9)
Three wires (8)
Feed wires (8) through switch body hole.
13. Switch body (2)
Wrap ends of wires (8) around
a.
Three contact
14. Three contacts (4)
screws (5) under washers (6).
screws (5), three
b. Screw in, and tighten screws (5)
washers (6), and
using 3/16-inch flat-tip screwdriver.
three wires (8)
c. Push insulator (7) over contact
screws (5).
Put in place.
Cover (1) and four
15. Switch body (2)
captive screws (3)
Screw in, and tighten using 3/16-inch
Four captive
16. Cover (1) and
flat-tip screwdriver.
screws (3)
switch body (2)
NOTE
FOLLOW-ON MAINTENANCE: Check operation of lights (page 2-22).
TA231238
TASK ENDS HERE
4-39