TM 9-2330-227-14&P
JUNCTION BOXES, 110-VOLT - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
INSTALLATION - CONTINUED
a. Feed wires through conduit assembly.
Conduit
28. Fitting (1)
assembly (2)
b. Put in place.
a. Screw in.
Nut (4)
29. Coupling (3) and
b. Tap left side of nut (4) toward
fitting (1)
van body (5) using 3/16-inch drive pin
punch and ball-peen hammer.
Using ball-peen hammer, tap in place.
Two covers (7)
30. Elbow (6)
a. Put cover (8) in place.
Cover (8) and
31. Fitting (1)
b. Screw in screw (9), and tighten using
screw (9)
3/16-inch flat-tip screwdriver.
c. Repeat steps 23 thru 31 b for other side.
Screw in all the way.
Bushing (11)
32. Nipple pipe (10)
a. Slip over two wires (14).
Nipple pipe (10)
33. Box (12),
b. Screw pipe (10) into nut (13) until
with bushing (11)
nut (13), and
tight.
two wires (14)
a. Screw in toward box (12).
34. Nipple pipe (10)
Bushing(n)
b. Using 3/16-inch drive pin punch and
and box (12)
ball-peen hammer. tap top of bushing
(11) toward van body (5) until tight.
Put in place.
Cover (15)
35. Box (12)
Screw in, and tighten using 3/16-inch
Four screws (16)
36. Cover (15) and
flat-tip screwdriver.
box (12)
37. Nipple pipe (10)
Screw in all the way.
Bushing (17)
Push in place.
36. Box (18)
Grommet (19)
Push in place.
Grommet (20)
39. Van body (5)
While feeding wires through hole, put
Box (18)
40. Van body (5) and
in place.
nipple pipe (10)
Four screws (21)
41. Box (18) and
Screw in, and tighten using number two
van body (5)
cross-tip screwdriver.
42. Box (18)
Feed through hole in top of box (18).
Two wires (22)