TM 9-2330-227-14&P
COMPOSITE LIGHT ASSEMBLY - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
REMOVAL - CONTINUED
CAUTION
Do not pull on wires, only pull connectors apart. Pulling on wires could damage them.
1. Frame (1)
Eight
Pull apart.
connectors (2)
Two screws (4) and
Using 9/16-inch socket and ratchet handle
2. Frame (1) and
Iockwashers (5)
with 3/8-inch drive, unscrew and take
composite light
out.
assembly (3)
Take off.
Composite light
3. Frame (1)
assembly (3)
LAMP, LENS, AND DOOR ASSEMBLY REPLACEMENT
4. Composite light
Using 3/16-inch flat-tip screwdriver,
Six captive
screws (6)
unscrew and take out.
assembly (3)
Door and lens assembly (7) will
come off with screws (6).
NOTE
Do not remove preformed packing unless damaged, deteriorated, and replacement is
necessary.
Preformed
Using 3/16-inch flat-tip screwdriver,
5.
packing (8)
pry out of groove.
Four lamps (10)
Push in, turn one-quarter turn
6. Composite light
body (9)
counterclockwise, and take out.
NOTE
Top lamp in light assembly is taillight, second lamp is stop-turn lamp, third down is
blackout taillight, and bottom lamp is blackout stoplight.
Four lamps (10)
Place in proper socket (11), push in, and
7.
turn one-quarter turn clockwise.
New preformed
If removed, place in groove.
8.
packing (8)
9. Composite light
Door and lens
Place in position.
body (9)
assembly (7)
4-50
