CLEARANCE LIGHT ASSEMBLY
This task covers:
a. Removal (page 4-58)
b. Installation (page 4-60)
INITIAL SETUP
Materials/Parts
Tools
Cloth, crocus (item 5, appendix E)
Knife, putty
Ladder, extension
Personnel Required
Screwdriver, cross-tip, number two
Screwdriver, flat-tip, 3/16-inch
One
ACTION
REMARKS
ITEM
LOCATION
NOTE
All clearance and blackout lights are removed and installed the same way. This task is
for one; repeat for the others.
If wire connectors are to be replaced or repaired, go to wire connector procedure
REMOVAL
Two screws (3)
Using 3/16-inch flat-tip screwdriver,
1. Lens housing (1)
unscrew and take out.
and light body (2)
Take off.
Lens housing (1)
2. Light body (2)
Using 3/16-inch flat-tip screwdriver,
Speed nut (4)
3. Lens housing (1)
pry off.
Pull out.
4.
Lens (5)
Lamp (6)
a. Push in, turn one-quarter turn
5. Light body (2)
counterclockwise, and take out.
b. Inspect for broken filament and
corrosion.
If corroded, clean with crocus cloth.
Check for corrosion.
6.
Socket (7)
If corroded, clean with crocus cloth.
4-58
