TM 9-2330-227-14&P
BLACKOUT STOPLIGHT ASSEMBLY
This task covers:
b. Lamps, Lens, and Door assembly
INITIAL SETUP
Personnel Required
Tools
One
Screwdriver, flat-tip, 3/16-inch
Socket, 3/8-inch drive, 1/2-inch
ACTION
REMARKS
ITEM
LOCATION
REMOVAL
NOTE
If wire connectors are to be repaired or replaced, go to wire connector procedure
Removal is not necessary for lamp, lens, or door assembly. For replacement, go to
step 4.
If circuit marker bands are missing or not readable, replace (page 4-73).
CAUTION
Do not pull on wires, only pull connectors apart. Pulling on wires could damage them.
Pull out.
End connector (2)
1. Blackout stoplight
assembly (1)
4-55