TM 9-2330-231-14&P
INSPECTION INSTRUCTIONS - CONTINUED
DRILLED AND THREADED HOLES AND SURFACES
Inspect for wear, distortion, cracks, or any other damage in or around holes and threaded surfaces.
Inspect threaded areas for wear, distortion, or evidence of cross threading.
Mark all damaged areas for repair or replacement.
METAL LINES, FLEXIBLE LINES (HOSES), AND METAL FITTINGS
Inspect metal lines for sharp kinks, cracks, bad bends, or if badly dented.
Inspect flexible lines for fraying, evidence of leakage, or loose metal fittings or connectors.
BUSHINGS
Inspect bushings for excessive wear, elongation, or grooving.
Section VII. ELECTRICAL SYSTEM
Page
Page
Blackout Stoplight .........................................
Main Harness ..............................................
Blackout Stoplight Lamp and Lens ..................
Marker Light.................................................
Composite Light ............................................
SERVICE TAILLIGHT....................................
COMPOSITE LIGHJT LAMP AND LENS ..........
Service Taillight Lamp and Lens ....................
Intervehicular Cable ........................................
Wiring Harness Repair ................................
4-34
BLACKOUT STOPLIGHT LAMP AND LENS
This task covers:
a. Removal (page 4-17)
b. Installation (page 4-17)
INITIAL SETUP
Tools
Materials/Parts
Screwdriver, flat-tip
Lamp
Packing (if required)
4-16
