TM 9-2330-247-14&P
S e c t i o n VI. ELECTRICAL SYSTEM MAINTENANCE
Page
Page
lntervehicular Cable . . . . . . . . . . . . . . . . . .
4-22
Blackout Stoplight Assembly . . . . . . . . . . .
Service Stoplight-Taillight Assembly . . . . .
Chassis Wiring Harness . . . . . . . . . . . .
Wiring Diagrams . . . . . . . . . . . . . . . . . . . . .
Composite Light Assembly . . . . . . . .
COMPOSITE LIGHT ASSEMBLY
This Task Covers:
Installation
c.
Removal
a.
b. Lamp, Lens, and Door Assembly Replacement
Initial Setup:
Tools/Test Equipment:
Equipment Conditions:
Handle, ratchet, 3/8 in. drive
Intevehicular cable disconnected from towing ve-
Screwdriver, flat-tip, 1/4 in.
hicle (para 2-12).
Socket, 3/8 in. drive, 9/16 in.
ACTION
REMARKS
ITEM
LOCATION
NOTE
Both composite light assemblies are replaced in the same way. Lamps, lens, and
door assemblies are also replaced in the same way. This procedure is for the left;
repeat for the right.
If wire connectors are to be repaired or replaced, refer to chassis wiring harness task
Removal is not necessary for lamp, lens, or door assembly replacement. If replacing
lamp, lens, or door assembly only, go to step 4. If circuit marker bands are missing or
illegible, replace (para 4-26).
