TM 9-2330-356-14
(m) Attach a suitable hoist to the drum (26)
(i) Install original number of thrust washers
and raise drum into position over frame. install spacer (16)
(25) over spacer (28).
between bearing and collar (17), and frame (15). Install
two capscrews (11), flatwashers (12), lockwashers (13), and
(j) Install collar (24) onto disc (20) using six
nuts (14). Next, install two capscrews (7), flatwashers (8),
capscrews (21), lockwashers (22), and nuts (23).
lockwashers (9), and nuts (10).
(k) Install disc (24)) over axle shaft (34), and
(n) Position pinion guard (4) and pinion
attach disc to four spacers (28) with four studs (18),
bearing assembly (5) onto frame (6), and secure to frame
lockwashers (74), and nuts (73). Tighten set screw (19).
with two capscrews (l), lockwashers (2), and flatwashers
(3). Be sure pinion-on-pinion bearing assembly (5) mates
(l) Install bearing and collar (17) onto axle
properly with bevel gear (51).
shaft (34). Lock onto shaft by rotating coIIar
e.
counterclockwise. Tighten set screw.
Section IV. METERS
Meter Head Seal Replacement.
b.
Meter (M970 and M970A1)
a.
General. The meters on the M969, M969A1,
(1) Cut security wire (fig. 8-9) and remove four
M970, and M970A1 semitrailers are not to be repaired
capscrews holding register head to meter body. Remove
except for replacement of the meter head seal on the
register.
M970 and M970A1 meter.
