TM 9-2330-356-14
c.
Cleaning, Inspection, and Repair.
(d) Reconnect hose reel wiring in motor
junction box (para 4-27).
(e) Replace motor junction box cover (55,
WARNING
Dry cleaning solvent P-D-680 Is toxic and
flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated
area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO
NOT use near open flame or excessive heat.
The solvent's flash point is 100F-138F
(38C-59C). If you become dizzy while
using cleaning solvent, immediately get fresh
air and medical help. If solvent contacts eyes,
immediately wash your eyes with water and
get medical aid.
(1) Clean metal parts with dry cleaning solvent
(item 11, Appendix E) and dry thoroughly.
(2) Inspect gears for worn, damaged, or missing
teeth. Replace gears if damaged.
d.
Assembly (Fig. 8-6).
(1) Assembly of Frame.
(a) Position one side angle (74) onto the two
frames (6 and 15). Secure in place with four capscrews
(73), lockwashers (70), and nuts (71),
(b) Install other side angle (74) onto the two
frames (6 and 15). Secure in place with four capscrews
(73), lockwashers (70), and nuts (71).
(c) Install both tie rods (72) onto the frames
(6 and 15). Secure with four capscrews (68), washers (69),
(3) Installation of Motor (Fig. 8-6).
lockwashers (70), and nuts (71).
(2) Installation of Terminal Board in Motor
NOTE
Junction Box (Fig. 8-7).
Be sure pinion gear teeth mesh properly with
the ring gear teeth.
(1) on the terminal board (3). Install the middle capscrew
(a) Install pinion gear (64) on motor shaft.
(4) and one nut (5) onto the terminal board.
Tighten set screw (63). - -
(b) Position the terminal in the motor
(b) Position motor between mounting
junction box (6). Install screw (7) but do not tighten. Install
bracket (62) and frame (6). Install four capscrews (59),
capacitors (8 and 9) onto screw (7). Be sure capacitors are
lockwashers (60), and nuts (61).
installed with marking in position shown in figure 8-7.
Tighten screw (7).
(c) Install bushing (58) into junction box
(57). Install assembly onto motor.
(c) Install lead with terminal (11) from
motor, along with capacitor lead, to terminal board.
(d) Connect the two motor leads to the
Secure with screw (10). Install motor lead with terminal
terminal board (65) in the junction box. Connect leads to
(11) and capacitor lead to screw (4). Install second nut (5)
terminal board and install conduit (para 4-27). Replace
cover (55) and secure with four machine screws (54).
and tighten.
8-10
