TM 9-2330-371-14&P
SERVICE BRAKES - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
ADJUSTMENT
NOTE
There are eight brakeshoes on this vehicle. This
task is for the adjustment of one. All brakeshoes are
adjusted the same way. Repeat this task as
necessary for other brakeshoes.
Nut (3), Iockwasher
Using 11/16-inch socket and handle, un-
Brakedrum (1) and
1.
(4), and inspection
screw and take off.
bolt (2)
hole cover (5)
Locknut (7)
Using 1 1/16-inch wrench, loosen.
Backing plate (6)
2.
Inspection hole (8)
a. Rotate brakedrum (1) until inspection
Brakedrum (1)
3.
hole (8) is approximately 1 1/2-
inches from end of one brake lining
nearest anchor pin (9).
b. Insert 0.005-inch feeler gage between
surface of drum and brake lining.
Anchor pin (9) and
a. Using 1/2-inch wrench, turn anchor pin
Backing plate (6)
4.
locknut (7)
until 0.005-inch clearance is obtained.
b. Using 1/2-inch wrench, hold anchor pin
and using 1 1/8-inch wrench, tighten
locknut.
Inspection hole (8)
a. Rotate brakedrum until inspection hole
Brakedrum (1)
5.
is 1 1/2 inches from other end of same
brakeshoe.
b. Insert 0.010-inch feeler gage between
surface of drum and brake lining.
Cam nut (10)
Using 11/16-inch wrench, turn until 0.010-
Backing plate (6)
6.
inch clearance is obtained.
Repeat steps 2 thru 6 for other
brakeshoe.
Nut (3), Iockwasher
Put on and tighten using 11/16-inch socket
Brakedrum (1) and
7.
(4), and inspection-
and handle.
bolt (2)
hole cover (5)