TM 9-2330-371-14&P
BRAKESHOES - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
INSPECTION AND CLEANING - CONTINUED
Retract spring (1),
a. Clean using drycleaning solvent PD-680
6.
anchor pins (2), re-
and brush.
tract spring pins
b. Dry using low-pressure air.
(3), guide pin
c. Inspect for damage or wear. If damaged
springs (4), and
or worn, replace.
cap washers (5)
Brake linings (7)
Inspect for damage or wear. If damaged or
Brakeshoes (6)
7.
worn, notify Direct Support Maintenance.
Anchor pin
Inspect for damage or excessive wear. If
8.
bushings (8)
damaged or worn, notify Direct
Support Maintenance.
Brakedrum (9)
Inspect for cracks, wear, scoring,
9.
warpage, and leaking. Replace as
required.
If any of these conditions exist,
both drums on an axle must be
replaced. Notify Direct Support
Maintenance.
Brake cylinder (10)
Inspect for cracks and leakage.
10.
Replace if required.
INSTALLATION
Two retract spring
Put in.
Two brakeshoes (6)
11.
pins (3)
Two cotter keys (11)
Put in and spread using straight jaw
Two retract
12.
pliers.
spring pins (3)
Two brakeshoes (6)
Put on and slide into place.
Two anchor pins
13.
Be sure brakeshoes and brake
(2) and brake
cylinder line-up properly.
guide pins (12)
Strap (13) and two
Put on using slip-joint pliers and hammer.
Two anchor
14.
C-washers (14)
pins (2)
Two springs (4),
Put on and tighten using 7/16-inch deep
Two brake guide
15.
four cap washers
well socket and handle.
pins (12)
(5), and two
nuts (15)