TM9-2330-374-14&P
4-18.
24 VOLT COMPOSITE MARKER LIGHT ASSEMBLY
INITIAL SETUP
Tools
General mechanics tool kit
Materials/Parts
2 4 volt composite marker light lamps
Tag wires to aid in installation.
If wire connectors
a r e to be repaired or replaced, go to wire connector
procedure (para. 4-28).
R e m o v a l is not necessary for lamp, lens, or door
a s s e m b l y replacement.
If circuit marker bands are
missing or not readable, replace (para. 4-28).
a.
Removal.
WARNING
D i s c o n n e c t all outside power before performing any
maintenance on the electrical system. Failure to do so
could result in serious injury or death.
CAUTION
Do not pull on wires, only pull connectors apart.
P u l l i n g on wires could damage them.
(1) Pull connectors (1, figure 4-5) apart.
(2) Remove two screws (2) and lockwashers (3) that hold 24 volt composite light
assembly (4) to bracket (5).
(3) Remove 24 volt composite light assembly (4).
