`TM9-2330-376-14&P
4 - 3 6 . INERTIA BRAKE HYDRAULIC TUBES AND HOSES REPLACEMENT (XM979 AND
XM1061).
This Task Covers:
b.
Installation
a.
Removal
lnitial Setup:
Materials/Parts:
Tools/Test Equipment:
Rags (Item 12, Appendix E)
General mechanic's tool kit
Nine Iockwashers
Drain pan
a.
REMOVAL.
NOTE
Use a drain pan to catch any draining brake fluid. Clean up all spills
1.
If necessary for access, remove reach tube (para 4-48) and inertia brake actuator and master cylinder assembly
2.
Disconnect tube assembly (1) from connector (18).
Loosen nut (2) and remove tube assembly (1) from nut (3).
3.
4.
Disconnect hose assembly (4) from nut (3). Remove nut from bracket (17).
Disconnect hose assembly (4) from multiple connector (15).
5.
Disconnect two tube assemblies (9) from multiple connector (15).
6.
7.
Remove screw (16), nut (13), Iockwasher (1 4), and multiple connector (1 5).
Disconnect tube assembly (9) from coupling (10).
8.
Remove two screws (5), Iockwashers (7), nuts (8), and clamps (6). Remove tube assembly (9). Discard
9.
Iockwashers.
10.
Disconnect tube assembly (11) from shuttle valve (12) and coupling (10).
11.
Remove two screws (5), Iockwashers (7), nuts (8), and clamps (6). Remove tube assembly (11). Discard
Iockwashers.
Repeat steps 8 through 11 to remove tube assemblies (9 and 11) on other side of trailer.
12,
INSTALLATION
b.
1.
Position tube assembly (11) on trailer.
2.
Connect tube assembly (11 ) to shuttle valve (1 2).
Install coupling (10) to tube assembly (11).
3.
4.
Install tube assembly (11 ) on trailer with two clamps (6), screws (5), new Iockwashers (7), and nuts (8).
4-62
