TM 9-2330-376-14&P
4 - 3 5 . INERTIA BRAKE ACTUATOR AND MASTER CYLINDER ASSEMBLY MAINTENANCE
( X M 9 7 9 AND XM1061) (Con't).
Remove connector (2) with tube assembly (3) attached from rear of inertia brake actuator assembly (1).
3.
4.
If damaged, remove two plugs (5) from reach tube (4) and discard.
DISASSEMBLY
b.
1.
Remove sleeve (17), thimble (18), and wire rope (33). Discard sleeve.
2.
Remove sleeve (34) from wire rope (33). Discard sleeve.
Remove two sleeves (14 and 32) and wire rope (13). Discard sleeves.
3.
4.
Remove tube assembly (26), elbow (21), reducer (28), and straight adapter (27).
Remove screw (25), Iockwasher (29), clamp (30), and accumulator (31). Discard Iockwasher.
5.
Remove two self-locking bolts (16), pawl (15), and two springs (12). Discard self-locking bolts.
6.
7.
Remove two self-locking bolts (20) and lever (19). Discard self-locking bolts.
Remove two spring pins (24), flatwashers (23), and pin (22). Discard spring pins.
8.
TA700961
4-57
