TM 9-2330-388-14
Figure 7-4. Fuel Rack Pin Alignment to Fork.
Figure 7-6. Removing Delivery Needle Valve
This is the moment when the pumping action of the
injection pump begins, and the reference mark on the
crankshaft support (flywheel side) must coincide with the
Figure 7-5. Installing Injector Pump
c. Unscrew the delivery connector to the
injection pump, remove the delivery needle valve but not
it's seat. Install the connector and delivery valve seat
d.
Connect the fuel tank to the injection pump.
e. Rotate the flywheel. At the beginning of the
compression stroke, fuel will be ejected from the fuel
pump delivery connector.
Figure 7-7. Pumping Beginning
f.
Keep on slowly rotating the flywheel in the
compression stroke, until the fuel ceases to come out.
7-3