TM 9-4110-255-14
WARNING
Battery explosion and personal injury can occur if positive lug is not installed first or if battery
posts are shorted.
(6) If no failure was indicated, install positive lug (8) using tag and wiring diagram (fig. 1-4) and tighten bolt
(9). Cover lug with red (positive) shield (7). Remove tag.
(7) Install negative lug (4) using tag and wiring diagram (fig. 1-4) and tighten bolt (5). Cover lug with black
(negative) shield (3). Remove tag.
b. Removal.
NOTE
Access to battery is best achieved through the top access panel.
(1) Tag wire leads (1) and (2). Pull the black (negative) shield (3) back to expose negative lug (4).
WARNING
Battery explosion and personal injury can occur if negative lug is not removed first or if battery
posts are shorted.
NOTE
Hardware is supplied with lug.
(2) Loosen bolt (5) and carefully remove lug (4) from battery (6).
(3) Pull the red (positive) shield (7) back to expose positive lug (8).
(4) Loosen bolt (9) and carefully remove lug (8) from battery (6).
(5) Remove four self locking nuts (10), flat washers (11), and battery clamp (12). Discard self locking nuts.
WARNING
Battery can explode and cause injury to personnel and equipment if battery is dropped or
punctured. Do not lift battery by terminals.
(6) Note position of shield (13) and remove battery (6), four L-bolts (14), and shield. If shield gaskets (15) are
damaged, notify direct support maintenance to replace them.
(7) If battery frame (16) is damaged, remove two screws (17), lock washers (18), flat wash rs (19), and
e
carefully pull differential oil pressure switch (20) away from battery frame. Discard lock washers.
(8) Remove two self locking nuts (21), clamps (22), and bolts (23). Carefully pull capillary tubing (24) away
from battery frame (16). Discard self locking nuts.
4-91
