TM 9-4110-255-14
(3) Loosen two set screws (8).
(4) Carefully pull condenser fan (9) off fan drive shaft (10) and remove.
b. Installation.
(1) Install condenser fan (9) onto fan drive shaft (10).
(2) Tighten two set screws (8) against flat surfaces on fan drive shaft (10).
(3) Install cap (7), flat washer (6), new lock washer (5), and bolt (4).
(4) Install access plate (3), eight new lock washers (2), and bolts (1).
NOTE
FOLLOW-ON MAINTENANCE:
Install fuel tank (para 4-67).
Close right side door.
Connect battery (para 4-35) and put unit back into service.
4-105
