TM 9-4120-370-14
TO 35E9-229-1
6-3.
DAMPER PARTS (MODELS F36T4-2S, F36T4-2SA, AND F36T-2S ONLY) - Continued.
Place rivet through hole in sleeve spacer and slip washer over end of rivet.
(3)
(4)
Carefully head the rivet. Check that louver blade arm swings freely on rivet pivot point.
Attach remaining louver blade arms repeating steps (2) through (4).
(5)
Place louver blade bearings in holes in fan outlet.
(6)
NOTE
The top three damper blades have gaskets, The bottom one does not.
(7)
Place the damper blade into the outlet opening. Insert the longer tab end through the slot in the inner
bearing. Carefully flex the damper blade enough to insert the short tab end through the slot in the outer
bearing.
Place the slotted ends of the louver blade arms onto the tab end of the damper blade. Place the damper
(8)
linkage arm (actuator link) on the top blade tab.
Secure linkages to damper blades with push on nuts.
(9)
(10) Check that dampers operate properly.
(11) Aline damper linkage arm with slot in actuator cylinder end and connect with shoulder bolt and flat washer.
1. Install lower front panel. (See para 425.)
Follow-on procedures:
2. Install actuating cylinder access cover. (See para 420.)
3. Install condenser outlet grilles. (See para 4-26.)
DAMPER PARTS (MODELS F36T-2S AND F36T4-2SB ONLY)
(See paragraph 6-3 for Models F36T4-2S, F36T4-2SA, and F36T-2S.)
See paragraph 5-15 for actuating cylinders and condenser air outlet damper linkage.
Preliminary procedures:
1. Remove condenser outlet grilles. (See para 426.)
2. Remove actuating cylinder access cover. (See para 4-20.)
3. Remove lower front panel. (See para 425.)
4. Remove condenser fans. (See para 4-63.)
5. Remove compressor. (See para 5-20.)
