TM 55-1930-208-10
Table 2-4. Operator/Crew Preventive Maintenance Checks and Services (PMCS-Continued
INTERVAL
PROCEDURES
EQUIPMNET IS
ITEM
ITEM TO BE
CHECK FOR AND HAVE REPAIRED
NOT READY/
NO
B
D
A
INSPECTED
OR ADJUST AS NECESSARY
AVAILABLE IF:
11
BILGE PUMP
Visually inspect for leaks
AND PIPING
or damage. Notify direct
support maintenance.
12
WINCH
Inspect windlass for loose
or missing mounting hard-
ware. Tighten or replace
loose or missing mounting
hardware. Lubricate in ac-
cordance with paragraph 3-1.
Inspect for kinked or im-
proper seated cable on drum.
Notify direct support main-
tenance.
13
ANCHOR
Inspect for corrosion.
Clean and paint. Inspect
latches and toggle pins.
Clean and paint. Notify
general support mainte-
nance if anchor is damaged.
14
CONTROL VALVE Inspect control valve for
Class III leaks
signs of damage. Refer to
are present.
control valve.
15
FILTER
Inspect for loose or mis-
Class III leaks
sing mounting hardware.
are present.
Inspect filter hoses and
fittings for leaks. Refer
to paragraph 3-14 for ser-
vicing filter.
16
RESERVOIR
Inspect for loose or mis-
Class III leaks
sing mounting hardware.
are present.
Tighten or replace loose or
missing hardware. Inspect
reservoir for leaks. Noti-
fy direct support mainte-
nance of a damaged reser-
voir. Service reservoir by
adding hydraulic fluid (item
10, Appendix D).
2-9
