SERVICE TAILLIGHT ASSEMBLIES
This task covers:
c. Installation (page 4-54)
a. Removal (page 4-52)
b. Lamp, Lens, and Door Assembly
Replacement (page 4-53)
INITIAL SETUP
Personnel Required
Tools
One
Handle, ratchet, 3/8-inch drive
Screwdriver, flat-tip, 3/16-inch
Socket, 3/8-inch drive, 9/16-inch
ACTION
ITEM
REMARKS
LOCATION
NOTE
Both service taillight assemblies are removed and installed, and lamp, lens and door
assemblies are replaced in the same way. These procedures are for one; repeat for
the other.
Tag wires to aid in installation page (4-4). If wire connectors are to be repaired or
replaced, go to wire connector procedure (page 4-71).
Removal is not necessary for lamp, lens, or door assembly replacement. If repairing
lamp, lens, or door assembly, go to step 4. If circuit marker bands are missing or not
readable, replace (page 4-73).
REMOVAL
CAUTION
Do not pull on wires, only pull connectors apart. Pulling on wires could damage them.
1. Frame (1)
Pull apart.
Six connectors (2)
2. Frame (1) and
Two screws (4) and
Using 9/16-inch socket and ratchet handle
service taillight
Iockwashers (5)
with 3/8-inch drive, unscrew and take out.
assembly (3)
Take off.
3. Frame (1)
Service taillight
assembly (3)
