TM 9-4120-370-14
TO 35E9-229-1
5-17. LOW PRESSURE CUTOUT SWITCH (S6) - Continued.
(9)
Leak test all newly connected joints and those in the repaired are. (See para 5-10.)
(10) Using screwdriver, secure the safety control box panel to the box with four flat head screws.
(11) Insert safety control box into unit taking care that capillary tubing is not damaged.
(12) Connect P16 connector and harness to J16 connector on back side of box.
(13) Using screwdriver, secure the safety control box to the unit with six screws, lock washers, and flat washers.
(14) Set the bottom of the lower front panel in position so that the flange is inside the lip on the cabinet base.
(15) Push the top of the panel back into position.
(16) Using screwdriver, tighten the five captive panel screws in the lower front panel.
Followon procedures:
1. On F36T2SA and F36T42SB install condenser discharge air deflector door. (See para
2. Connect power.
3. Press and release pressure switch buttons to be sure they are not tripped.
5-18. HIGH PRESSURE CUTOUT SWITCH (S5)
Preliminary procedures:
1. On F36T2SA and F36T42SB remove condenser discharge air deflector door. (See para
2. Pull safety control box out far enough to gain access to panel mounting screws. (See para