TM 9-2330-227-14&P
WIRE HARNESS, 110-VOLT, CONNECTOR RECEPTACLE-TO-MAIN CIRCUIT BREAKER
This task covers:
a. Removal (page 5-6)
b. Installation (page 5-6)
INITIAL SETUP
Personnel Required
Tools
One
Handle, ratchet, 3/8-inch drive
Screwdriver, flat-tip, 3/8-inch
Equipment Condition
Socket, 3/8-inch drive, 1/2-inch
Socket, 3/8-inch drive, 7/16-inch
Connector receptacle, 110-volt, removed
Insulation removed as required to access
harness (page 4-173).
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
Harness (2)
Pull through.
1. Inside front
wall (1)
2. Two clamps (3)
Two screws (4) and
Using 3/8-inch flat-tip screwdriver,
nuts (5)
7/16-inch socket, and ratchet handle with
3/8-inch drive, unscrew and take off.
3. Harness (2)
Two clamps (3)
Using 3/8-inch flat-tip screwdriver,
spread and take off.
4. Frame (6)
Harness (2)
Take off.
INSTALLATION
Harness (2)
Place in position.
5.
6. Harness (2)
Two clamps (3)
a. Put in position.
b. Put on harness (2).
7. Two clamps (3)
Two screws (4) and
Screw together, and tighten using 3/8-inch
nuts (5)
flat-tip screwdriver, 7/16-inch socket,
and ratchet handle with 3/8-inch drive.
5-6
