TM 9-2330-227-14&P
WIRE HARNESS, 24- VOLT, RUNNING LIGHTS
This task covers:
a. Removal (page 5-13)
b. Installation (page 5-18)
INITIAL SETUP
Personnel Required
Tools
One
Pliers, diagonal cutting
Screwdriver, cross-tip, number two
Equipment Condition
Screwdriver, flat-tip, 3/16-inch
Wrench, box-end, 7/16-inch
Connector receptacle removed (page 4-74).
Insulation removed as required to get
Materials/Parts
to harness (page 4-173).
Wire, safety (item 22, appendix E)
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
NOTE
The 24-volt wire harness is disconnected from all service, clearance, and identification
lights the same way. Repeat this procedure for others.
Tag wires to aid in installation (page 4-4). If circuit marker bands are missing or not
readable, replace (page 4-73).
Pull apart.
Three connectors (3)
1. Harness (1) to
clearance
lights (2)
5-13
