TM 9-2330-356-14
(5) Remove linkage pin which connects solenoid
(b) The clearance should be between
shaft to linkage (fig. 4-124).
0.070-inch and 0.120-inch (as near to 0.070-inch as
possible).
(6) Remove two screws that fasten solenoid to
starter motor. Remove solenoid.
(c) Adjust the link screw on the end of the
solenoid plunger for proper clearance.
Installation.
b.
(2) Raise engine air shutter and position the
(1) Position starter solenoid on starter motor and
starter motor and shield on engine. Install top retaining
fasten with two screws.
capscrew (11) and washer (12) on starter. Using a 3/8-inch
drive set, long extension, universal joint, and a 9/16-inch
(2) Connect starter linkage to solenoid using
universal socket, install bottom starter capscrew (13) and
linkage pin.
washer (14).
(3) Attach hot lead No. 6 to large bottom pole of
(3) Secure starter support bracket to starter
solenoid and lead No. 74 to small pole.
using capscrew (7), washer (8), and nut (9). Do not tighten.
(4) Replace starter solenoid protective shield.
(4) Using capscrew (5) and washer (6) secure
Fasten with two capscrews and washers.
starter support bracket to engine. Tighten capscrew (7),
washer (8), and nut (9).
(5) Connect negative battery cable to battery
(5) Attach leads No. 74 and No. 6 to starter
solenoid.
4-81. Buss Bar
(6)
Replace the five capscrews (4) on engine air
shutter.
WARNING
(7) Connect negative battery cable to battery
When performing electrical maintenance,
ALWAYS disconnect intervehicular electrical
cable from semitrailer, and negative battery
cables at batteries. Failure to follow this
warning may create a spark and explosion,
resulting in serious injury or death to
personnel.
WARNING
When performing electrical maintenance,
Replacing Buss Fuse (Fig. 4-125).
a.
ALWAYS disconnect intervehicular electrical
cable from semitrailer, and negative battery
(1) Disconnect negative battery cable from
cables at batteries. Failure to follow this
battery (fig. 4-37).
warning may create a spark and explosion,
resulting in serious injury or death to
(2) Remove buss bar cover (fig. 4-125) by
personnel.
removing two capscrews and nuts.
(3) Remove buss bar fuse from its clips.
a.
Removal.
(4) Install new fuse between clips.
(1) Remove negative battery cable from battery
(5) Replace buss bar cover. Attach to firewall
with two capscrews and nuts.
(2) Starter solenoid removal must be done from
underneath the vehicle on the left side of the engine.
(6) Reconnect negative battery cable to battery
(3) Remove starter solenoid protective bracket
(1) by removing the two retaining capscrews (2) and
b.
Removal.
washers (3).
(1) Perform steps (1) through (3) of paragraph a.
(4) Remove hot lead No. 6 from large bottom
(2) Disconnect all electrical leads from buss bar.
pole of solenoid and lead No. 74 from small pole.
