TM 9-2330-356-14
b.
Inspection and Repair.
tube with hole in mounting bracket, and install retaining
screw (28), washer (27), and self-locking nut (26).
(1) Inspect spindle ends on trunnion cross tube
(2) Install mounting bracket (22), and fasten to
for damaged threads, pitting, scoring, or wear on finished
support bracket with four screws (25) washers (24), and
surfaces. Hand chase the threads to remove minor
nuts (23). Tighten to 450-650 lb.-ft. Install retaining screw
damage or burrs.
(28), washer (27), and self-locking nut (26).
(2) Use straightedge and check for bends in the
(3) Install torque rods on mounting bracket
trunnion cross tube. Replace the tube if not serviceable.
(4) Install spring seat and spring (para 6-3).
(3) Check that plugs (29) are installed in both
ends of tube.
and M970A1 including M970 SN TC-0843, TC-
c.
Installation.
0844, and TC-103 thru TC-178) (Fig. 6-2).
a.
(1) Insert one end of trunnion cross tube into
mounting bracket attached to semitrailer. Aline hole in
b.
including M970 SN TC-0843, TC-0844, and TC-103 thru TC-178).
Change 3
