TM 9-2330-356-14
(5) Remove top capscrew (21), lockwasher (22),
b.
and grille retainer (31) from the blower housing grille (5).
NOTE
(6) Remove eight capscrews (23), two capscrews-
(24), two washers (25), and capscrew (26). Remove blower
To remove blower housing only, the top air
housing (6).
removed. The two capscrews (18) and
c.
washers (19) securing air housing cover to
blower housing must be removed to remove
(1) Remove the high temperature switch
blower housing.
(1) Disconnect air cleaner hose at the engine air
(2) Pull high temperature switch leads out
through hole in air shutter box.
(2) Disconnect the fuel hoses from the fuel tank
(3) If blower housing was not previously
(4) Remove three capscrews (30) and washers
(31), and remove air shutter assembly. Remove forward
securing engine fan shroud (8) to frame (9) and panel (5).
rocker cover for clearance.
Remove engine fan shroud.
d.
remove.
(1) Remove throttle cable only at engine
(2) If air shutter was not previously removed,
capscrews (28), and three washers (29). Remove rear
cylinder housing (1).
e.
NOTE
the top air housing cover (2), rear cylinder
housing (1), and blower housing (6) must be
removed.
(1) Disconnect the hot lead from the fuel shutoff
solenoid, the two leads from the oil pressure switch, and
Disconnect large lead from the manifold heaters
6. Screw (4)
1. Capscrew (5)
from the governor linkage (1) by removing nut (21) from
7. Nut (4)
2. Nut (5)
the ball joint (22).
8. Fan shroud
9. Frame
4. Panel
(3) Remove all fuel lines (para 7- 19).
5. Panel
TA100C83
(4) Remove two screws (30, fig. 7-9), and remove
Shroud.
bottom cylinder pan (3).