TM 9-2330-371-14&P
SPLASH SHIELDS - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
NOTE
There are two splash shields on the semitrailer. This
procedure is for one. Repeat the procedure for the
other.
REMOVAL
Nut (3), bolt (4),
Using 9/16-inch wrench, 9/16-inch
Splash shield (1)
1.
washer (5), and
socket, and handle, unscrew and take
and bracket (2)
Iockwasher (6)
out.
Two hinges (8) and
Using tape measure, note locations for
Splash shield (1)
2.
bracket (2)
installation.
and frame (7)
Weldments (9)
Using portable grinder, take off.
Two hinges (8)
3.
It may be necessary to use a hammer
and bracket (2)
and chisel to separate parts after
grinding off weldments.
Weldments (9)
Using portable grinder, take off to
Frame (7)
4.
prepare surfaces for new parts.
INSTALLATION
Bracket (2)
Mark location on frame (7) using
a.
Frame (7)
5.
measurements taken before removal.
b.
Clamp bracket to frame using C-clamp.
c.
Weld using arc welder.
See TM 9-237.
Two hinges (8)
Mark location on splash shield using
a.
New splash
6.
measurements taken before removal.
shield (1)
b.
Clamp hinges to splash shield using C-
clamps, and weld using arc welder.
See TM 9-237.